How Do You Troubleshoot A PCM?

How much does it cost to fix a PCM?

The PCM controls more than 100 factors in your car, and for that reason, is very important – and expensive.

A typical pcm replacement cost comes to between $500 and $1,500 on average..

Can you test a PCM?

You need to check the sensors that are connected to your PCM, as well as the wires that connect them. If you’re seeing a PCM code – or two, or three – it can really help you narrow in on which sensors or wires are faulty. Perform a visual inspection of these wires, as well as checking them with a multimeter.

Is ECM and PCM the same thing?

PCM (Powertrain Control Module) – This is a combined engine and transmission control unit which will provide management and correct function of the engine and transmission from one control unit. ECU (Engine Control Unit) / ECM (Engine Control Module) – This is an electronic control unit that manages the engine only.

Why would a PCM need to be reprogrammed?

PCM Reprogramming is also necessary to change the engine idle speed, spark timing, fuel mixture or other emission control functions. PCM Reprogramming may be required to resolve a hot or cold starting issue, idle roughness, stalling, or an emissions failure.

What are the symptoms of a bad PCM?

Usually a bad or failing ECU will produce a few key symptoms that can alert the driver of a potential issue.Check Engine Light comes on. An illuminated Check Engine Light is one possible symptom of a problem with the ECU. … Engine stalling or misfiring. … Engine performance issues. … Car not starting.

What causes a PCM to fail?

PCMs typically fail for one of two reasons: voltage overloads (often due to a short in a solenoid or actuator circuit) or environmental factors (corrosion, thermal stress or vibration). … If water gets inside a PCM, it can short circuits and set up irreversible corrosion that ruins electronic connections.

How do I reset my PCM?

How Can I Reset the PCM on My Car?Open the hood of the vehicle.Disconnect the negative battery cable from the battery. Use a wrench to loosen the lock nut, and pull the cable off. This cuts the power to the PCM. Wait for five minutes. Reconnect the negative battery cable to the battery and close the hood of the vehicle. The PCM is now reset.

Will a bad PCM throw a code?

The PCM should give you a code for P0600 through P0606 indicating that the computer has a processor error. However, if the PCM is corrupt, then just like a desktop computer, there is no accessing anything and no codes are put out for the computer would have no way of sending a signal.